Hello Suso,
Now I can say my 3D router is ready (without finnish all the side of the wood).
Not All the secondary parts, as follower and 3D-Follower, But the machine is ready now.
I spent a lot of time to fine tune the squareness and play free of the bearing guides. I added adjust screws. I have used lager bearings (32x10) {Much cheaper} of course a bus was needed to the bolt.
Later I can send you more pictures off the details.
The angle guides are 15x15x3. From that way I made a grove for more space (see picture 0073 and 0074).
A small detail: all the wood was free !!
Kind regards
Jan
